Data Acquisition:  

PCI-8133 3-CH AB PhaseEncoder/Counter And PWM Output Card   Dual interrupt from two timer clock signals Compact size–only half-size PCB One 37-pin rugged SCSI-II connector for encoder signals, one 40-pin header connector for digital I/O expansion     Features 32-bit PCI Bus, Plug and Play Three quadruple AB phase encoder counters 16-bit up down counters On-board 5000V rms isolation circuits and digital deglitch filters for every encoder input signal Programmable frequency for digital deglitch filter Three PWM waveform generators 12-bit PWM signal resolution Isolation general purpose 8 DI & 8 DO

Specifications Counter of Encoder Input Number of channels: 3 Counter resolution: 16-bit Encoder counter Type Up-down counter Digital filter for input signal A, B phase and index input Counter 1 input signal types: A, B phase decoder input VCO (CCW+CW pulse) input Counter 2 input signal types: A, B phase decoder input Pulse command input Counter status read back Filter type: 3-order digital filter Digital filter frequency: programmable 10MHz,  5MHz, 2.5MHz, 625KHz PWM Signal Output Number of channels: 3 Signal resolution: 12-bit Base frequency: 10MHz PWM cycle is synchronized with interrupt signal Isolation Digital Output / Input Number of input channels: 16 DI Number of output channels: 16 DO Input voltage: 0-24Vdc Input resistance: 1.2KW @ 0.5W Digital output type: Darlington Transistors, open collector  up to 40Vdc Sink current: 500mA max. Isolated voltage: 5000V rams General Specification Connector: one 37-pin D-type female and one 40-pin  header connector Interrupt sources: (Dual Interrupt) Internal Timer Clock A Internal Timer Clock B Operating temperature: 0°~ 55°C Storage temperature: -20°~ 80°C Humidity: 0~95%, non-condensing Dimensions: 162 mm x 105 mm Software Support PCI-8133Library &Utility for DOS  library and Windows 95/NT DLL, shipped with card. Termination Boards *ACLD-9137 * ACLD-9188 *DIN-37D Order Information PCI-8133 3-CH AB Phase Encoder/Counter and PWM  Output Card

** PCI-8134: 4-Axis Motion Control Card ** Introduction The PCI-8134 is a PCI based motion control card for 4-axis. It can gene-rate high-frquency pulses to drive stepping motors and/or pulse train input servomotors. Using this card, you can perform continuous motion control, in-positioning and origin return in various ways including constant speed and linear acceleration/ deceleration Features Two sets of bi-axial control ASIC Linear interpolation for two-axises Maximum output frequency of 1.2 Mpps Out-of-step detection for stepping motor 28 bits up down counters Programmable pulse setting rate Programmable acceleration / deceleration rate Major operations available Continuous operation Preset operation Origin return Linear interpolation   * Will be available soon !

 

© Copyright 2004 - Arista Corporation